Excellent ≥ −60Good −67Slow −74Spotty −81No signal
Signal lost per wall
How to use the lab
This is a model home with one Wi-Fi router. Explore where the signal reaches, then add mesh units to fill the gaps.
Look aroundDrag to rotate the house. Scroll or pinch to zoom. Right-drag (or two fingers) to slide the view. The buttons at the top jump to the whole house, the backyard, or a floor plan.
Add floorsPress Add 2nd floor or Add basement under Floors. With both added you see all three floors at once. Use the Floor buttons at the top left to look at one level, or All floors to see them together. To place a unit, pick one floor first.
Read the signalFloor colors show strength: green is excellent, amber is slow, red is spotty, and red stripes mean no signal. Point at any spot (or tap it) to see its reading in dBm and a rough speed.
Follow the lessonThe lesson card walks through 10 short steps. Press the blue button on each step to see it happen, then Next.
Add a mesh unitChoose Indoor or Outdoor mesh unit, move over the house to preview the coverage, then click or tap to place it. Press Esc to cancel.
Move or removeDrag any unit, including the router, to a new spot. Click a unit to select it, then press Remove. The dashed line shows its link back to the router: green is strong, red is weak.
Check your coverageThe coverage check lists 7 devices around the home. Try to get all 7 to "Good" or better. Switch between 5 GHz and 2.4 GHz to compare, and use Start over to reset.
Open this guide again from ? How to use, top right.